Premium Custom 29 inch Driveshaft for Early Bronco
This driveshaft has been designed for use with early Broncos, and can fit a variety of transmission/lift combinations. Please measure and verify length needed prior to ordering. This driveshaft has a centered running length of 29.25 inches from center to center of the two outermost u-joints. Collapsed length is 26.75 inches. Extended length is 31.75 inches. This drive shaft fits Dana Spicer 1310 series transfer case yokes.
Custom 29 inch Early Bronco Driveshaft:
- 2 inch DOM tubing
- Full length splines for longer travel
- Custom H-block & CV joint for better angle range of motion
- Forged slip yokes & splined shafts for added strength
- Steel CV center housing for added strength.
The splines on our premium driveshafts are fully splined for much better and stronger engagement, whereas the splines on our standard driveshafts only extend a portion of the slip shaft.
Fit
1966-77 Ford Bronco
Technical Specs
- Fits Broncos with Dana Spicer 1310 style transfer case yokes.
- If you have a Cleveland style yoke, you will need to also purchase a new transfer case yoke and driveline bolt kit to complete your installation.
- To tell if you have a Cleveland or Spicer style transfer case yoke, measure the distance between the mounting holes on the yoke where the driveshaft connects. A Cleveland yoke will measure 1 7/8 inches from center hole to center hole. A Spicer yoke will measure 1 1/2 inches from center hole to center hole.
WARNING: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. Learn more
-
1 of 1 Premium Custom 29 inch Driveshaft for Early Bronco
