Skip to main content

Premium Stock Length Rear Driveshaft for Early Bronco

$440.00 $396.00

TOMS OFFROAD premium rear heavy duty stock length driveline for 66-77 Ford Broncos. This driveshaft generally fits Broncos with stock transmission from stock height to a 2.5 inch suspension lift. If you have a non-stock transmission, please measure and verify length needed prior to ordering. This early Bronco drive shaft fits Dana Spicer style 1310 cv transfer case yokese.

Premium Factory Length Early Bronco Driveline:
  • 2 inch DOM tubing
  • Full length splines for longer travel
  • Custom H-block & CV joint for better angle range of motion
  • Forged slip yokes & splined shafts for added strength
  • Steel CV center housing for added strength.
  • Collapsed length measures 31.13 inches. Extended length measures 36.13 inches

This is a great alternative to running a factory, non-hd driveline when running a higher horsepower motor where strength is of upmost importance.



The splines on our premium driveshafts are fully splined for much better and stronger engagement, whereas the splines on our standard driveshafts only extend a portion of the slip shaft.

Technical Specs

  • Fits 1966-77 Ford Broncos with Dana Spicer style 1310 CV transfer case yokes
  • Please select your transmission, differential and suspension height using the drop-down menus. This will help us to double-check that the driveshaft you are ordering will be correct for your application. This is only for reference and not a guarantee of fitment for application. To ensure proper fitment, you should always verify that the running length of the driveshaft is appropriate for your application by measuring your current setup.

Prop. 65 Warning for California Residents

WARNING: This product may contain chemicals known to the state of California to cause cancer, birth defects, or other reproductive harm. Learn more